Measuring non-factory installed tower

Note: All measurements to be made in inches (1 inch = 2.54 cm)

 
Measurement #1
Start on the starboard side (drivers side) Measure from center of nose (Figure 1) along the rub rail to the center of first tower leg. (Figure 2) (a friend makes this easier see Figure 3)

Starboard Measurement #1

 inches
Port Measurement #1 inches
Measurement #2
From center of rub rail measure vertically to center of tower leg base (Figure 4)
Starboard Measurement #2 inches
Port Measurement #2 inches
Measurement # 3
From center of first tower leg base measure along the rub rail to the second tower leg base.
Starboard Measurement #3 inches
Port Measurement #3 inches
 
 

Figure 1 >>

Figure 2 >>

Figure 3 >>

Figure 4 >>